Minebea CSD-581-15 - Page 18

6−2−2. Operation in another modes 48.....................................
6−3. “ZERO” key 48.........................................................
6−3−1. Operation in the Measurement mode 48.............................
6−4. “FUNC.” key 48........................................................
6−4−1. Operation in the Measurement mode 48.............................
6−4−2. Operation in another modes 48.....................................
6−5. “CHECK” key 48.......................................................
6−5−1. Operation in the Measurement mode 48.............................
6−5−2. Operation in another modes 48.....................................
6−6. “ENTER” key 48.......................................................
7. Function and operation 49..................................................
7−1. External control input signal and open collector output signal 49............
7−1−1. External control input signal 49....................................
7−1−2. Open collector output signal 50.....................................
7−1−3. Equivalent circuit 50..............................................
7−2. BCD output 51.........................................................
7−2−1. Related function 51...............................................
7−2−2. Specifications for BCD output 51...................................
7−2−
3. BCD output connector pin configuration 52..........................
7−2−4. Equivalent circuit for input/output 53...............................
7−2−5. Timing chart 53..................................................
7−2−6. Output condition 55...............................................
7−2−7. Selection of output logic for P.C.(Print command), and its width 55....
7−3. How to use filter 57.....................................................
7−3−1. Digital filter 57...................................................
7−4. Zero tracking 58........................................................
7−4−1. What is zero tracking? 58..........................................
7−4−2. Setting related with zero tracking 58................................
7−4−3. Target of zero tracking 58..........................................
7−4−4. Cancellation for data compensation by Zero tracking 59...............
7−5. Stabilizing filter 60.....................................................
7−5−1. What is stabilizing filter? 60........................................
7−5−2. Setting related with stabilizing filter 60.............................
7−6. Various kinds of functions related with display 62..........................
7−6−1. Selection of target of display on load display 62.......................
7−6−2. Selection of target of HOLD 62.....................................
7−6
−3. Range of load display 62...........................................
7−7. Change of bridge power supply voltage 63.................................
7−8. Tare weight cancelation (A/Z) 64.........................................
7−9. Zero set 64.............................................................
7−10. Digital Tare weight cancellation 64.......................................
7−11. Key lock 65............................................................
7−12. CHECK value 65.......................................................
7−13. Memory position for setting data and so on 66.............................
7−14. Check mode 66.........................................................
7−14−1. Operating procedures for the Check mode 67.........................
7−15. Monitor mode 72.......................................................
8. Function mode 74..........................................................
8−1. Setting method for Function mode 74.....................................
8−2. Function on Function data 76............................................