Minebea CSD-581-15 - Table of Contents

CONTENTS
FORWARD Ⅰ.......................................................
Marks and arrangement used in this manual Ⅱ.......................
For safe operation Ⅲ...............................................
1. Installation place Ⅲ.........................................................
2. Power supply Ⅵ.............................................................
3. Application note Ⅵ..........................................................
Conformity of CE standard Ⅸ....................................................
1. Storage case Ⅸ.............................................................
2. Connecting wires Ⅹ.........................................................
Record of revision ⅩⅢ.............................................................
1. General 1.................................................................
1−1. Features 1..........................................................
2. Each name and function 2.................................................
3. Installation procedures 4..................................................
3−1. Installation place 4....................................................
3−2. Location where installation is not allowed. 4.............................
3−3. Installation 5.........................................................
4. Connecting method 7......................................................
4−1. Layout of terminals and BCD output connector 7.........................
4−2. Note on connection 8..................................................
4−3. Connections 9.........................................................
4−3−1. Connection with strain gage applied transducers 9..................
4−3−2. Connection with external control input 17...........................
4−3−3. Connection with open collector output 18............................
4−3−4. Connection with power supply and ground 19........................
5. Calibration procedures 20...................................................
5−1. Preparations 20........................................................
5−2. Calibration procedures 20...............................................
5
−2−1. Calibration method to register the output of strain gage applied transducer at the time of
maximum display after setting the loa 21...........................................
5−2−2. Calibration method to register the output of strain gage applied transducer at the time of
zero and the maximum display 26.................................................
5−2−3. Calibration method to register by reading output value of strain gage applied transducer in
the conditions at zero and actual lo 31.............................................
5−2−4. Fine adjustment on zero 37........................................
5−2−5. Fine adjustment on span 39........................................
5−2−6. Calibration procedure to apply registration again for zero point only 41
5−3. Selection of calibration procedures on each condition 43....................
5−3−1. In case of executing the calibration on new instrument. 43............
5−3−2. In case of executing re−calibration 46...............................
6. Operating procedures 47....................................................
6−1. “A/ZA” key 47..........................................................
6−1−1. Operations in Measurement mode 47...............................
6−1−2. Operations in another modes 47....................................
6−2. “A/Z OFF Y” key 47....................................................
6−2−1. Operation in Measurement mode 47................................