Minebea CSD-581-15 - Page 16

XIV
Date
Instruction manual No.
Details of revised point
Jan.2018 DRW. NO.EN294-1107-L
Due to ECN FN17-02017
・Delete the company name in the contents.
Due to FN17-02066E
Add and correct the applicable standard.
- Add [EN50581･2012]
- Correct from [EN61326-1:2006] to [EN61326-1:2013]
Mar.2018 DRW. NO.EN294-1107-M
Due to ECN FN15-02132B
－Correct miswriting－
1. Installation place
・Dimensions for installation
・Dimensions when the optional metal cover(CSD581−P80)
is installed.
3. Application note
2. Each name and function
3−3. Installation
4−3−1.○
1E
AConnection with strain gage applied transducers
4−3−1.
A○
2E
Ai) In case of application of CAB−502 (4 cores cable)
ii) In case of application of CAB−501(6 cores cable)
4−3−1.
A○
3E
Ai) In case of application of CAB−502(4 cores cable)
ii) In case of application of CAB−501(6 cores cable)
4−3−1.
A○
4E
Ai) In case of application of CAB−502 (4 cores cable)
ii) In case of application of CAB−501(6 cores cable)
4−3−2. Connection with external control input
4−3−3. Connection with open collector output
4−3−4. Connection with power supply and ground
7−2−7. Selection of output logic for P.C.
(Print command), and its width
7−7. Change of bridge power supply voltage
10−11. Outline dimensions
12−1. Replacement of fuse
12−2. Attachment/removal of optional metal cover
(CSD581−P80)
－ Additional－
2. Each name and function