EasyManuals Logo

Minolta DIMAGE SCAN MULTI II F-3100 User Manual

Minolta DIMAGE SCAN MULTI II F-3100
125 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
– 8
CPU: Power PC, Power Macintosh G3, Blue & White Power Macintosh G3 and
Power Macintosh G4
(Except for 68 K Macintosh and Mac OS compatible unit)
Power Macintosh G4 is recommended when loading with 16 bit and using
the Digital ROC/GEM functions.
Operation System: Mac OS 7.5.3 to 9.0.4
Memory: A minimum of 32 MB (megabytes) application RAM in addition to the
requirements for the Mac OS.
256 MB or more when loading with 16 bit and using the Digital ROC/GEM
functions.
Hard Disk Space: About 600 MB or more of available hard disk space.
About 2 GB or more of available hard disk space when loading with 16 bit
and using the Digital ROC/GEM functions. (About 3 GB or more is
recommended.)
Monitor: Minimum 13 (640 x 480) inch monitor capable of displaying at least 32,000
Colors.
19 inch(1024 x 768) or larger is recommended.
CD-ROM Drive: Necessary (when installing the software.)
Recommended SCSI Board:
With a Power Macintosh and Power Macintosh G3
The standard built-in SCSI board
Connecting to the extension board inserted into the PCI bus/NuBus is not
available.)
With a Blue & White Power Macintosh G3*, Power Macintosh G4
Adaptec PowerDomain 2940UW/U2W, PowerDomain 2930U, SCSI Card
2906, and AVA-2903B
* Some models in the Blue & White Power Macintosh G3 series use the
Ultra2 Wide SCSI board as the standard built-in SCSI board, however,
connecting the Dimage Scan Multi II to the standard built-in SCSI board is
not recommended. The connecting capacity may be limited and the full
capabilities of the PC may not be usable due to the specifications of the
standard built-in SCSI board.
When using the model which has the standard built-in SCSI board, insert
the recommended SCSI board as described above in the open slot without
detaching the standard built-in SCSI board and then connect the Dimage
Scan Multi II to the SCSI connctor on the inserted SCSI board.
Other: Adobe PhotoShop Ver. 4.0.1, Ver. 5.0.2, Ver. 5.5 and Adobe Photoshop 5.0
LE have been fully tested for use with the plug-in software.
SYSTEM REQUIREMENTS – MACINTOSH

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Minolta DIMAGE SCAN MULTI II F-3100 and is the answer not in the manual?

Minolta DIMAGE SCAN MULTI II F-3100 Specifications

General IconGeneral
BrandMinolta
ModelDIMAGE SCAN MULTI II F-3100
CategorySoftware
LanguageEnglish