Minolta DIMAGE SCAN MULTI II F-3100 User Manual

– 9 –
To use the Dimage Scan Multi II, install the software by following the procedure below.
CAUTION – Before installing
• Make sure that the Damage Scan Multi II is connected to your PC correctly. For connecting the
Dimage Scan Multi II to the PC, refer to the hardware instruction manual.
• The antivirus system extensions may conflict with the operation of this installer. Remove or
disable any extensions before launching this installer and replace or re-enable them when
installations are complete.
INSTALL THE SOFTWARE
These installation instructions assume drive C or D is the CD-ROM drive or the startup disk drive
respectively.
WINDOWS 95/98/98SE/2000/NT4.0
Turn on the Dimâge Scan Multi II.
1
Turn on the PC and start up Windows.
• The“[New Hardware Found” window will appear.
2
Click on [Next >] in the first dialog
box.
3a
Click on [Finish] in the second dialog
box.
3b
Select “Do not install a driver.” and
click on [OK].
• This dialog box may appear several times.
Repeat step 3 until the dialog box no longer
appears.
3
FOR WINDOWS 2000/NT4.0
FOR WINDOWS 95 RELEASE 2 (OSR2)
• The 2 dialog boxes shown on the left will
appear.
Click on [Next >] until [Finish]
appears and Click on [Finish] at last.
3
Insert the Dimâge Scan Multi II CD-
ROM into the CD-ROM drive.
4
FOR WINDOWS 98

Minolta DIMAGE SCAN MULTI II F-3100 Specifications

General

Brand	Minolta
Model	DIMAGE SCAN MULTI II F-3100
Category	Software
Language	English