Mircom 9500 Series User Manual

MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 29
1. By using *888 for Menu Driven type of programming.
2. By using the Direct Access Programming Codes for manual programming. Entering these codes will lead the
user directly to the desired function. The Direct Access Programming Codes are listed in the table below.
Code Function Factory
Default
Program Choices
*000 Exit Programming Mode *000 n/a NONE
*101 Enter Resident/Tenant Codes
and Relay Numbers
Blank See worksheet 4 digit resident
code and 4 digit
relay number
*202 Review Resident/Tenant
Codes, Relay Numbers and
Resident/Tenant Names
Blank See worksheet Up to 23 digits to
review or delete
4 + 4 +15
*303 Enter Keyless Entry Codes Blank See worksheet 4 digits
*404 Review Keyless Entry Codes Blank See worksheet 4 digit code to
review or delete
*505 Change Master Code *999 *___ ___ ___ 3 digits
*606 Change Number of Ring Cycles 6 cycles ___ ___ cycles 2 digits
*707 Set Door Open Timer 10 seconds ___ ___ seconds 2 digits
*808 Set On Line Timer 60 seconds ___ ___ seconds 2 digits
*909 Select MULTIPLE/SINGLE
Entrance
Multi (00) ___ ___ 00 Multi or
11 Single (2 digits)
*111 Enter 1st 11-digit Telephone
Number
Blank (_) _ _ _ _ _ _ _ _ _ _ 4-digit area code
and 7 digit
telephone number
*222 Enter 2nd 11-digit Telephone
Number
Blank (_) _ _ _ _ _ _ _ _ _ _ 4-digit area code
and 7 digit
telephone number
*333 Auto Programming
Residents’/Tenants’ Dial Codes
None Qty_ _ _ Code:_ _ _ _ 3-digit maximum
resident capacity
4-digit starting point
for resident codes
*777 Select Digit for Hold 3 __ 1, 2 or 3
"NO MANUAL" MENU DRIVEN PROGRAMMING USING *888

Mircom 9500 Series Specifications

General

Brand	Mircom
Model	9500 Series
Category	Intercom System
Language	English