EasyManua.ls Logo

Mircom 9500 Series - Select Digit for Hold

Mircom 9500 Series
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 39
- Please Wait -
Sorting Residents'/Tenants’ names may take a few minutes depending on the number of names to sort. The next
screen should change to... Performing copy ...
- Please Wait -
When finished, the system should exit to PROGRAM MODE menu. To quit, enter *000 while at PROGRAM
MODE menu to return to NORMAL MODE.
NOTE: Sorting cannot be performed with more than 600 names in a scrolling directory.
SELECT DIGIT FOR HOLD
To select the digit to put the caller on hold, scroll through until you reach the feature as shown below
[1=Bck] [3=Fwd]
Do you want to
Program HOLD?
[*=Abort] [#=Yes]
Press # to select hold digit. The display will be...
[1=Bck] [3=Fwd]
Hold on digit
1,2, or 3 (_)
[*=Abort] [#=Yes]
Type in the digit you require and then press # to store entry or * to abort. To quit, enter *000 while at PROGRAM
MODE menu to return to NORMAL MODE.
* * * * End of Programming * * * *
FIG. 18: 9501A, 9502A, and 9503 CONTROLLER’S RESET PINS & FUSES

Table of Contents

Related product manuals