Mircom 9500 Series User Manual

MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 30
While in the programming mode, enter the "*888" to gain access to the programming menu. After entering *888,
the screen should appear...
[1=Bck] [3=Fwd]
Welcome to the NSL
On-Line Help Menu!
[*=Abort] [#=Yes]
1 and 3 keys are for scrolling backward or forward the feature menus.
# to access the displayed feature.
* to quit, exit, cancel or abort.
Press 3 for the next menu. The screen should appear...
[1=Bck] [3=Fwd]
Do you want to exit
from PROGRAM Mode?
[*=Abort] [#=Yes]
1 inactive key
3 key to the first feature menu.
# key to exit to Normal Mode.
* key to Programming Mode menu
Note: Repeat the above scrolling process (i.e. pressing keypad 3) to locate the desired feature. To exit to
Normal Mode, enter *000 while in the PROGRAM MODE menu.
Press 3 again for the next menu.
MANUAL ENTRY OF RESIDENTS'/TENANTS’ DIAL CODES and RELAY #
Residents'/Tenants’ Dial Codes and Relay # can be entered in the format of 1, 2, 3, or 4 digits (less than 4 digits
must be preceded by 0's). These codes are used to call the residents using the Entry Panel's keypad. Use the
information given on APPENDICES "D-1 and D-2" to program the Residents'/Tenants’ Dial Codes and Relay #.
To enter codes manually, scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to enter
TENANT Codes ?
[*=Abort] [#=Yes]
Press # to access feature. The screen should display...
Enter: 000x for one (1) digit dial code
-Program Options- Enter: 00xx for two (2) digits dial code
Code Relay# Enter: 0xxx for three (3) digits dial code
_ _ _ _ _ _ _ _ Enter: xxxx for four (4) digits dial code
Please enter choice: To call a resident with two digits dial codes, simply enter xx
Where: 0 - Zero, x - Resident Dial Code (digit 0 to 9)
Enter Resident/Tenant Dial Code and Relay/Line number as per APPENDICES D-1and D-2. When you make a
mistake and wish to re-enter the code, press * to enter code again. After entering the Code and Relay number, the
next screen should display...
-Program Options-
* = Abort, # = Store
xxxx xxxx

Mircom 9500 Series Specifications

General

Brand	Mircom
Model	9500 Series
Category	Intercom System
Language	English