MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 33
-Program Options-
KEYLESS Entry
Code #_ _ _ _
Please enter choice:
Enter the four digits Keyless Entry Code. If you make a mistake or wish to re-enter the code, press * to enter code
again. The next display should change to...
-Program Options-
* = Abort, # = Store
Code # x x x x
Please enter choice:
Press * to abort or # to store entry. Repeat this process until all codes are entered. We recommend not to use the
same keyless entry code. Press any number from 1-9 to exit to PROGRAM MODE menu when finished. To quit,
enter *000 while at PROGRAM MODE menu to return to NORMAL MODE.
REVIEW AND DELETE KEYLESS ENTRY CODES
To review and delete Keyless Entry Codes, scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to edit
KEYLESS Codes ?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
-Program Options-
Code To Review
# _ _ _ _
Please enter choice:
Enter the Keyless Entry Code to review or delete. The next display should appear...
-Program Options-
KEYLESS Entry
Code # x x x x
Please enter choice:
Press 1 or 3 to scroll (review) "up or down" the list. To delete the displayed code, press #.
When finished, press * to exit to PROGRAM MODE menu for programming other functions. To quit, enter *000
while at PROGRAM MODE menu to return to NORMAL MODE.
REPROGRAMMING MASTER CODE
Master Code (factory default is *999) may be changed to any desired three (3) digits code number. Since this
code is used to access all levels of programming, it would be a good idea to change the code to one that will be
known only by the installer or management personnel. Please enter the new Master Code in the space provided
below for future reference.
New Master Code: ___________________ Date: ______________________
To Next Page
Loading...
Need help?
General
