Mircom 9500 Series User Manual

MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 34
To change the MASTER CODE, scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to edit
the MASTER Code ?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
-Program Options-
MASTER Code
*_ _ _
Please enter choice:
Enter the New Master Code.Please do not use *888 for Master Code.The next display should appear.
-Program Options-
* = Abort, # = Store
* x x x
Please enter choice:
Press * to abort or # to store entry. The next display should appear...
-Program Options-
Press *
To exit
Please enter choice:
Press * to exit to PROGRAM MODE menu. To quit, enter *000 while at PROGRAM MODE menu to return to
NORMAL MODE.
Note: To restore factory default Master Code, please see FIG. 18 for location of reset pins.
SET DOOR TIMER
To change Door-Open Timer (factory default is 10 seconds), scroll through until you reach the feature as shown
below.
[1=Bck] [3=Fwd]
Do you want to edit
the Door-Open Timer?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
-Program Options-
Door-Open Timer
00 to 99 Sec. x x <----99 seconds max.
Please enter choice:
Enter the desired door-open period. The next display should appear...
-Program Options-
* = Abort, # = Store
00 to 99 Sec. x x
Please enter choice:

Mircom 9500 Series Specifications

General

Brand	Mircom
Model	9500 Series
Category	Intercom System
Language	English