MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 44
REVIEW AND DELETE KEYLESS ENTRY CODES
To review and delete keyless entry codes, scroll through until you reach the feature as shown below.
To Edit KEYLESS
Codes - Press #
Press # to access feature. The display should appear...
Code To Review
# _ _ _ _
Enter the Keyless Entry Code to review or delete. The next display should appear...
KEYLESS Entry
Code # x x x x
Press 1 or 3 to scroll up or down the list. To delete the displayed code, press #.
When finished, press * to exit to PROGRAM MODE menu for programming other functions. To quit, enter *000
while at PROGRAM MODE menu to return to NORMAL MODE.
REPROGRAMMING MASTER CODE
Master Code (factory default *999) may be change to any desired three (3) digit code number. Since this code is
used to access all levels of programming, it would be a good idea to change the code to one that will be known
only by the installer or management personnel. Please enter the new Master Code in the space provided below for
future reference.
New Master Code: ___________________ Date: ______________________
To change the MASTER CODE, scroll through until you reach the feature as shown below.
To Change MASTER
Code - Press #
Press # to access the feature. The display should appear...
MASTER CODE
*_ _ _
Enter the New Master Code. Please do not use *888 for Master Code.The next display should appear...
#=Store, *=Abort
* x x x
Press # to store or * to abort entry. The next display should appear...
Press *
To exit
Press * to exit to PROGRAM MODE menu. To quit, enter *000 while at PROGRAM MODE menu to return to
NORMAL MODE.
NOTE: To restore Master Code, please see FIG. 18 for location of reset pins.
To Next Page
Loading...
Need help?
General
