MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 43
AUTO PROGRAMMING THE RESIDENTS'/TENANTS’ DIAL CODE
This feature is provided to allow the user to program the Dial Codes automatically. In addition, the user can specify
the codes start number which enhances the flexibility compared to traditional MIRTEL 9000 series.
Scroll through until you reached the feature as shown below.
To Auto Program
Codes - Press #
Press # to access the feature. The display should appear...
Program Codes
from: _ _ _ _
Enter the desired start number for DIAL CODES. The system should automatically program the codes
incrementally by one (1). Please note that the Relay/Line Number will always start at 0000. For example, the start
number is (say) 1500, the data stored in the memory should be as shown below.
Code Relay number
1500 0000
1501 0001
1502 0002
etc.
While the system is programming, the message will appear...
Now PROGRAMING!
- Please Wait -
When finished, the system should exit to PROGRAM MODE menu. To quit, enter *000 to return to NORMAL
MODE.
PROGRAMMING THE KEYLESS ENTRY CODES
The system can provide up to 1000 Keyless Entry Codes for residents and 5 spares for building management. The
Keyless Entry Codes allow authorized residents to enter a code directly at the keypad to release the door without
the necessity of calling the resident/tenant. For obvious reasons, keyless entry codes should be kept well guarded
and controlled. [Operation: press # followed by the four digits Keyless Entry Code]
Scroll through until you reached the feature as shown below.
To Enter KEYLESS
Codes - Press #
Press # to access the feature. The display should appear...
KEYLESS Entry
Code #_ _ _ _
Enter the four digits Keyless Entry Code. If you make a mistake or wish to reenter the code, press * to enter code
again. The next display should change to...
#=Store, *=Abort
Code # x x x x
Press # to store or * to abort entry. Repeat this process until all codes are entered. Press * to exit to PROGRAM
MODE menu when finished. To quit, enter *000 while at PROGRAM MODE menu to return to NORMAL MODE.
To Next Page
Loading...
Need help?
General
