MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 37
[1=Bck] [3=Fwd]
Do you want to set
the Time-of -Day ?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
-Program Options-
Hr Mn Sc
_ _ : _ _ : _ _ <----Hour : Minute : Second
Please enter choice:
Enter the Time-of-Day. To quit, enter *000 while at PROGRAM MODE menu to return to NORMAL MODE.
TWO 11-DIGITS TELEPHONE NUMBER ENTRY (9501A)
The system has a built-in Dedicated Telephone Jack that can be connected to a standard residential jack (RJ-
11/CA-11). The user can program two ( up to 11-digit) telephone numbers that can be auto-dial through the
telephone network. Each telephone number has its own dial code. To take advantage of this unique feature, a
touch tone (DTMF) line is required.
To enter the FIRST 11-digit telephone number, scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to set
the 1st 11-digit # ?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
-Program Options-
(1) Code: _ _ _ _
_ - _ _ _ - _ _ _ - _ _ _ _ <----up to 11 digits telephone number
Please enter choice:
Enter Dial Code and telephone number. If less than 11 digits are required, simply press # to blank the remaining
digit(s). When you make a mistake and wish to re-enter the code, press * to enter code again. After entering the
telephone number, the display should appear...
-Program Options-
* = Abort, # = Store
x - x x x - x x x - x x x x
Please enter choice:
Press * to abort or # to store entry. To quit, enter *000 while at PROGRAM MODE menu to return to NORMAL
MODE.
To enter the SECOND 11-digit telephone number, scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to set
the 2nd 11-digit # ?
[*=Abort] [#=Yes]
To Next Page
Loading...
Need help?
General
