MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 28
PROGRAMMING INSTRUCTIONS: SCROLLING DIRECTORY
Before programming the system, obtain the required information by using the forms provided in APPENDICES "D-
1 and D-2". Some information may be found on APPENDICES "B-1 and B-2".
The following programming information pertains to both the 9501A and the 9502A unless otherwise specified.
After the system initializations (power up), the display should appear as shown below.
< MIRCOM >
Enter Resident Code
to view directory
press * UP # DOWN
This is the Normal Mode of the system. The system will accept all valid Access Codes by entering them directly
on the keypad. Use the * or # key to scroll "up or down" the resident directory list. Pressing the * or # key
momentarily will scroll "up or down" the directory list one name at a time. Holding the * or # key will scroll "up or
down" continuously and stop scrolling when the key is released.
Before entering the Programming Mode for the first time, it is recommended to restore the factory default Master
Code *999 by shorting the reset pins for approximately 3 seconds. Please see page 34, Fig. 18 for reset pins
location.
Note: Shorting the reset pins will only restore the factory default Master Code *999 and will not affect any
programmed information.
ENTERING PROGRAMMING MODE
While in the Normal Mode, press "0" then enter the MASTER CODE (factory default is *999) to enter the
PROGRAMMING MODE.
Pressing "0", the screen should appear ...
< MIRCOM >
***** _ _ _ _ *****
*******************
-Keyless Entry Mode-
Pressing "*", the next screen should appear...
< MIRCOM >
***** * _ _ _ *****
*******************
-Program Code Entry
Enter Master Code (default is 999), the next screen should appear...
< MIRCOM >
PROGRAM MODE
-Please Wait-
-Program Code Entry-
for a few seconds, then the screen should change to...
<<< PROGRAM MODE >>>
Enter the three
digit program code
[Use *888 for Menu]
This is the PROGRAM MODE menu. At this stage, the system is waiting for valid programming code.
Important note: Before programming the system for the first time, it is recommended to clear the memory and restore all factory defaults
by using a special command *5*5 while in the Program Mode menu . Since this special command (*5*5) is a destructive
command which can erase all the programmed information without the provision to undo, the user must take precaution
when using this command.
There are two ways to program the system.
To Next Page
Loading...
Need help?
General
