USER GUIDE
Mitel 5634 VoWi-Fi Handset
4.2
Incoming Calls
During the incoming call, the handset’s number or the name of the caller is displayed on the
screen accompanied with a ring signal and/or vibrating alert.
The ring signal and vibration can be disabled. The ring signal can be also configured to be
available in both headset and loudspeaker, or only loudspeaker. For the details, please refer to
the
Mitel 5634 VoWi-Fi Handset Configuration Guide
.
The name is displayed if the caller’s handset number is stored in the local phonebook.
The handset can be configured to show the contents of the display (except for the Soft key bar)
upside down at incoming calls. This feature can be configured directly on the handset (refer to
the Rotate Display Text, page 44) or using the WinPDM/WSM3/CPDM3 DM. For the details,
please refer to the
Mitel 5634 VoWi-Fi Handset Configuration Guide
.
4.2.1
Answer the Call
There are several ways to answer an incoming call on the handset:
•
When the call is received, press the Call key or Accept to answer the call.
It is possible to configure the handset to answer the call with any key instead of the Call key
as well as to change the answering behavior into Automatically, Loudspeaking, or Quick
answer. For the details, refer to the 8.6.6 Answering, page 45.
•
When the call is received, press the Loudspeaker icon in the Soft key bar to answer the
call in loudspeaking mode.
•
When the call is received, press the headset button to answer the call
3
.
4.2.2
Decline the Call
When the call is received, press the End call key to reject the call.
If the handset is configured to respond to the declined calls with a predefined message, the Reply with
a message template? dialog window appears. For more information, please refer to the 5.6.2 Decline
the Call with a Message Template, page 28.
4.2.3
End the Call
While in a call, press the End call key or the End soft key to finish the call. The duration of the call
is shown on the display.
4.3
Missed Calls
The dialog window that appears for a missed call can be turned off by the system administrator.
The handset can also be configured to not store any calls in the Call list to ensure privacy for
the users sharing the same handset. These features require configuration in the handset via
WinPDM/ WSM3/CPDM3 DM.
When a missed call dialog window is shown, you can:
3.
Applicable only if a headset is connected to the handset.
To Next Page
Loading...
