Making a Consultation Call
In addition to a conference call, the UC360 supports a separate independent call with one
remote party. This is referred to as a consultation call.
• Consultation calls are audio only. They cannot be video enabled.
• There can be a maximum of one consultation call at a time, though up to two more incoming
consultation calls can be queued.
To make a consultation call:
Note: There must already be an active call.
1. Tap the Saucer icon
The Contacts app is displayed. (See “Contacts App” on page 31.)
2. Select the contact and make the call.
When you are connected to the consultation call, the call fly-out bar is expanded to show more
information. The conference call and rest of the Conference App background is blurred and
the controls in the Conference App are not available as you can see in the diagram above.
When you switch back to the conference call again, the saucer icon goes back to its contracted
position.
To learn more about consultation calls, see “Saucer Icon” on page 28.
To Next Page
Loading...
Need help?
General
