UC360 Administration and User Guide
Camera Settings
1. Press Settings
2. Press Advanced
3. Press System Settings
4. Press Camera Settings
The Network camera has the following settings:
• Enabled - Allows the ethernet camera to be enabled or disabled.
• IP Address/Host Name
- This is the IP address (IPv4) or host name of the ethernet camera. The IP address may
have previously been manually programmed into the ethernet camera or the camera
may have obtained the address from a DHCP server.
- If a DNS server is being employed, then the ethernet camera can be addressed with
the host name of the camera. The DNS server will perform the IP address lookup
based on the host name.
- If the camera is using DHCP, then use the camera manufacturer-provided utility to find
the IP address.
• Username - Sets the username for access to the ethernet camera.
• Password - Sets the password for access to the ethernet camera
• Brightness - Adjust the brightness of the ethernet camera
See Ethernet Cameras in the UC360 Engineering Guidelines for detailed information.
To Next Page
Loading...
