Mitsubishi Electric Evolution+ s-MEXT - Page 63

63
Version 38
Mask of the terminal
Description
Par.N.
Settings
--------------- P22.85
Fire/smoke event type:
A-M
Parameter for setting the type and reset of the Fire/Smoke event.
Visible only if smoke/fire sensor management is enabled.
22.85
Settings
--------------- P22.88
External dumper alarm
enable: N
--------------- ------
----------------------
Enable the control of the external damper alarm (not controlled by the logic).
Delay time before activation of the external damper alarm.
22.88
Settings
--------------- P22.94
Low supply temp.
alarm setpoint: 10°C
--------------- P22.95
High supply temp.
alarm setpoint: 32°C
Low air delivery temperature alarm setpoint.
High air delivery temperature alarm setpoint.
22.94
22.95
Settings
--------------- P22.96
Low supply humidity
alarm setpoint: 30%RH
--------------- P22.97
High supply humidity
alarm setpoint: 80%RH
Low air delivery humidity alarm setpoint.
High air delivery humidity alarm setpoint.
22.96
22.97
Settings – KIPlink
Status:Offline
WiFi Network SSID:
KIPlink_032000000
IP Address:
000.000.000.000
Channel: WiFi
Display of the status and main information of the KIPlink module.
Settings – KIPlink
Module type:
Master-EthOFF-WiFiON
Display of the type of KIPlink module.
Settings – KIPlink
Ethernet channel:
IP: 192.168.030.001
Sub:255.255.255.000
Gw: 000.000.000.000
Display of information on the KIPlink Ethernet network.
Settings – KIPlink
WiFi channel:
IP: 192.168.030.001
Sub:255.255.255.000
Gw: 000.000.000.000
Display of information on the KIPlink Wi-Fi network.
Settings – KIPlink
Network Info
SSID master:
KIPlink_032000000
IP master:
192.168.030.001
KIPlink ID: 01
Display of the main information of the Priority module of the KIPlink network.