Mitsubishi Electric Evolution+ s-MEXT - [P24] Adjustments Menu

68
Version 38
2.5.14 [P24] Adjustments Menu
Accessible from: “Service” group.
Mask of the terminal
Description
Par.N.
Adjustments
 
Access mask to “Adjustments” menu.
Adjustments
--------------- P24.01
Return air temperature
probe adj.: 0.0°C
--------------- P24.02
Return air humidity
probe adj.: 00.0%RH
Parameter for ambient temperature probe calibration.
Parameter for ambient humidity probe calibration.
Visible only if the air return T/H probe is enabled.
24.01
24.02
Adjustments
--------------- P24.03
Supply air temperature
probe adj.: 0.0°C
--------------- P24.04
Outdoor air temp.
probe adj.: 0.0°C
Delivery air temperature probe calibration.
External air temperature probe calibration.
24.03
24.04
Adjustments
--------------- P24.08
Circ 1 Low Pressure
probe adj.: 0.0bar
--------------- P24.09
Circ 1 suction temp.
probe adj.: 0.0°C
Circuit 1 low pressure probe transducer.
Circuit 1 inlet temperature probe calibration.
24.08
24.09
Adjustments
--------------- P24.10
Circ 2 Low Pressure
probe adj.: 0.0bar
--------------- P24.11
Circ 2 suction temp.
probe adj.: 0.0°C
Circuit 2 low pressure probe transducer.
Circuit 2 inlet temperature probe calibration.
24.10
24.11
Adjustments
--------------- P24.20
Remote T+H 1 temp.
probe adj.: 0.0°C
--------------- P24.21
Remote T+H 1 humid.
probe adj.: 00.0%
Parameter for calibrating the remote temperature / humidity sensor 1.
Visible only if at least one serial remote T+H probe is configured.
24.20
24.21
Adjustments
--------------- P24.40
Remote 2 T+H temp.
probe adj.: 0.0°C
--------------- P24.41
Remote 2 T+H humidity
probe adj.: 00.0%
Parameter for calibrating the remote temperature / humidity sensor 2.
Visible only if at least two serial remote T+H probes are configured.
24.40
24.41
Adjustments
--------------- P24.42
Remote 3 T+H temp.
probe adj.: 0.0°C
--------------- P24.43
Remote 3 T+H humidity
probe adj.: 00.0%
Parameter for calibrating the remote temperature / humidity sensor 3.
Visible only if at least three serial remote T+H probes are configured.
24.42
24.43