8 - 6
8. SPECIAL ADJUSTMENT FUNCTIONS
8.5.3 Parameters
When using the gain changing function, always set "
4 " in parameter No.2 (auto tuning) to choose the
manual mode of the gain adjustment modes. The gain changing function cannot be used in the auto tuning
mode.
Parameter
No.
Abbrevi
ation
Name Unit Description
6 PG1 Position control gain 1 rad/s
36 VG1 Speed control gain 1 rad/s
Position and speed gains of a model used to set the response
level to a command. Always valid.
34 GD2
Ratio of load inertia moment to
servo motor inertia moment
Multiplier
(
10
1
)
35 PG2 Position control gain 2 rad/s
37 VG2 Speed control gain 2 rad/s
38 VIC Speed integral compensation ms
Control parameters before changing.
61 GD2B
Ratio of load inertia moment to
servo motor inertia moment 2
Multiplier
(
10
1
)
Used to set the ratio of load inertia moment to servo motor inertia
moment after changing.
62 PG2B
Position control gain 2 changing
ratio
Used to set the ratio (
) of the after-changing position control
gain 2 to position control gain 2.
63 VG2B
Speed control gain 2 changing
ratio
Used to set the ratio (
) of the after-changing speed control gain
2 to speed control gain 2.
64 VICB
Speed integral compensation
changing ratio
Used to set the ratio (
) of the after-changing speed integral
compensation to speed integral compensation.
65 CDP Gain changing selection Used to select the changing condition.
66 CDS Gain changing condition
kpps
pulse
r/min
Used to set the changing condition values.
67 CDT Gain changing time constant ms You can set the filter time constant for a gain change at changing.
To Next Page
Loading...
