3 - 45
3. SIGNALS AND WIRING
3.11 Servo amplifier connectors (CNP1, CNP2) wiring method (When MR-ECPN1-B and MR-ECPN2-B of an
option are used.)
POINT
For the wire sizes used for wiring, refer to Table 13.1 1), 2) and 3) of section
13.2.1.
(1) Termination of the cables
Solid wire: After the sheath has been stripped, the cable can be used as it is.
8 to 9 mm
Twisted wire: Use the cable after stripping the sheath and twisting the core. At this time, take care to avoid
a short caused by the loose wires of the core and the adjacent pole. Do not solder the core
as it may cause a contact fault.
To Next Page
Loading...
