1 - 3
1. FUNCTIONS AND CONFIGURATION
1.3 Servo amplifier standard specifications
Servo amplifier
MR-E-
-QW003
Item
10A 20A 40A 70A 100A 200A
Voltage/frequency
3-phase 200 to 230VAC, 50/60Hz or 1-phase 230VAC,
50/60Hz
3-phase 200 to 230VAC,
50/60Hz
Permissible voltage fluctuation
3-phase 200 to 230VAC:
170 to 253VAC, 50/60Hz
1-phase 230VAC: 207 to 253VAC, 50/60Hz
3-phase 170 to 253VAC,
50/60Hz
Permissible frequency fluctuation Within 5
Power supply
Power supply capacity Refer to section 12.2
Inrush current Refer to section 12.5
Control system Sine-wave PWM control, current control system
Dynamic brake Built-in
Protective functions
Overcurrent shut-off, regenerative overvoltage shut-off, overload shut-off (electronic thermal
relay), encoder error protection, regenerative error protection, undervoltage, instantaneous
power failure protection, overspeed protection, excessive error protection
Max. input pulse frequency 1Mpps (for differential receiver), 200kpps (for open collector)
Command pulse multiplying factor Electronic gear A: 1 to 65535 B: 1 to 65535, 1/50 A/B 50
In-position range setting 0 to 10000 pulse (command pulse unit)
Error excessive 2.5 revolutions
Position control mode
Torque limit Set by parameter setting
Speed control range Internal speed command 1: 5000
Speed fluctuation ratio
0.01 or less (load fluctuation 0 to 100 )
0
(power fluctuation 10 )
Internal speed
control mode
Torque limit Set by parameter setting
Structure Self-cooled, open (IP00)
Force-cooling,
open (IP00)
[ ] 0 to 55 (non-freezing)
Operation
[
] 32 to 131 (non-freezing)
[ ] 20 to 65 (non-freezing)
Ambient
temperature
Storage
[
] 4 to 149 (non-freezing)
Operation Ambient
humidity
Storage
90
RH or less (non-condensing)
Ambient
Indoors (no direct sunlight)
Free from corrosive gas, flammable gas, oil mist, dust and dirt
Altitude Max. 1000m above sea level
Environment
Vibration 5.9 [m/s
2
] or less
Mass [kg] 0.7 0.7 1.1 1.7 1.7 2.0
To Next Page
Loading...
