Mitsubishi Electric EZMOTION MR-E Super MR-E-70A-QW003 - Cables and Connectors

13 - 6
13. OPTIONS AND AUXILIARY EQUIPMENT
13.1.2 Cables and connectors
POINT
Protective structure indicated for cables and connecters is for a cable or
connector alone. When the cables and connectors are used to connect the
servo amplifier and servo motor, and if protective structures of the servo
amplifier and servo motor are lower than that of the cable and connector,
specifications of the servo amplifier and servo motor apply.
(1) Cable make-up
The following cables are used for connection with the servo motor and other models. Those indicated by
broken lines in the figure are not options.
14)
12)
13)
9)
13)
Power supply
Analog monitor
Analog moniter
Power supply connector
Brake connector
Encoder connector
CNP1
CNP2
CN3
CN1
CN2
Servo motor
HF-SE JW1-S100
Regenerative
option
6)
1) 2) 40) 41)
34) 35)
10) 11) 20) 21)
28) 29)
18) 19) 22) 23)
15) 16) 17)
3) 4) 5)
7) 8)
36) 37) 38) 39)
20) 21) 22) 23)
Operation
panel
Controller
Servo amplifier
30) 31) 32) 33)
24) 25) 26) 27)
Personal
computer
Direct connection type (cable length 10m or less, IP65)
To 24VDC power
supply for
electromagnetic
brake
Junction type (cable length more than 10m, IP20)
Power supply
connector
Brake
connector
Encoder
connector
Servo motor
HF-KE W1-S100
www.DataSheet4U.com