5 - 7
5. PARAMETERS
Class No. Symbol Name and function
Initial
value
Unit
Setting
range
Control
mode
5 INP In-position range
Used to set the in-position signal (INP) output range in the command pulse
increments prior to electronic gear calculation.
100 pulse 0
to
10000
P
6 PG1 Position loop gain 1
Used to set the gain of position loop.
Increase the gain to improve track ability in response to the position
command.
When auto turning mode 1,2 is selected, the result of auto turning is
automatically used.
35 red/s 4
to
2000
P
Position command acceleration/deceleration time constant
(position smoothing)
Used to set the time constant of a low-pass filter in response to the position
command.
You can use parameter No.55 to choose the primary delay or linear
acceleration/deceleration control system. When you choose linear
acceleration/deceleration, the setting range is 0 to 10ms. Setting of longer
than 10ms is recognized as 10ms.
POINT
7 PST
When you have chosen linear acceleration/deceleration, do not
select control selection (parameter No.0) and restart after
instantaneous power failure (parameter No.20). Doing so will cause
the servo motor to make a sudden stop at the time of position control
switching or restart.
3 ms 0
to
20000
P
Example: When a command is given from a synchronizing detector,
synchronous operation can be started smoothly if started during line
operation.
Synchronizing
detector
Start
Servo amplifier
Servo motor
Without time
constant setting
Servo motor
speed
Start
With time
constant setting
ON
OFF
t
Basic parameters
8 SC1 Internal speed command 1
Used to set speed 1 of internal speed commands.
100 r/min
0 to
instan-
taneous
permis-
sible
speed
S
To Next Page
Loading...
