Mitsubishi Electric MELSEC iQ-R-R00CPU - Page 869

APPX
Appendix 5 List of Special Register Areas
867
A
*1 The start I/O number (first three digits in four-digit hexadecimal representation) of each module
*2 The built-in Ethernet port for the RnENCPU
*3 The CPU module where this function can be used supports these special register areas.
SD1381 Details on iQ Sensor
Solution data backup/
restoration error
(device 1)
Information of the
device (device 1)
where an error has
occurred
• This register stores the information of a device (device 1) where
an error of the iQ Sensor Solution data backup/restoration has
been occurred. When errors are detected in multiple devices, the
information of a device (device 1) where the error detected first is
stored.
<AnyWireASLINK>
ID number
<CC-Link and CC-Link IE Field Network>
Station number
<Ethernet>
IP address (lower 16 bits)
Example: When the IP address is 192.168.3.40, 3 = 3H and 40 =
28H. Therefore, the value of lower 16 bits (0328H) is 808.
• This register is cleared to 0 when the right to use is acquired or
the backup/restoration is requested.
S (Status
change/Error)
Rn
*3
SD1382 Details on iQ Sensor
Solution data backup/
restoration error
(device 2)
Information of the
device (device 2)
where an error has
occurred
• This register stores the information of a device (device 2) where
an error of the iQ Sensor Solution data backup/restoration has
been occurred. When errors are detected in multiple devices, the
information of a device (device 2) where the error detected first is
stored.
<AnyWireASLINK>
0 (Not used)
<CC-Link and CC-Link IE Field Network>
Station sub-ID number
<Ethernet>
IP address (upper 16 bits)
Example: When the IP address is 192.168.3.40, 192 = C0H and
168 = A8H. Therefore, the value of upper 16 bits (C0A8H) is 49320.
• This register is cleared to 0 when the right to use is acquired or
the backup/restoration is requested.
S (Status
change/Error)
Rn
*3
No. Name Data stored Details Set by
(setting
timing)
CPU