APPX
Appendix 1 I/O Signals
253
A
Stop request from a program
A BACnet module can be stopped using a program with the following procedure.
■ CheckYDevice in the BACnet detail setting is '0'
A BACnet module cannot be stopped using a program.
■ CheckYDevice in the BACnet detail setting is '1'
Operation of a BACnet
module
X0 X1 X2 Operation in a program Y1 Remarks
BACnet communication is in
operation.
111 1 In operation
The value of Y1 is changed to '0' to
issue a stop request.
10
BACnet leaving processing is
started.
0
After the module has left from
BACnet, the value of X2 is changed
to '0'.
10
The BACnet communication is
stopped.
0 The value of X2 is changed to '0' and
the BACnet communication is regarded
as stopped.
To Next Page
Loading...
