Mitsubishi Electric MELSEC iQ-R - Page 257

APPX
Appendix 1 I/O Signals
255
A
Restart request from a configuration function
When the [Restart] button is clicked in a configuration function, an operation restart processing is performed with the following
procedure.
■ CheckYDevice in the BACnet detail setting is '0'
■ CheckYDevice in the BACnet detail setting is '1'
Operation of a BACnet module X0 X1 X2 Remarks
The BACnet communication is stopped. 1 0 0 
 The [Restart] button is clicked in a configuration
function.
When the [Restart] button is clicked in a configuration function, the
value of X1 is changed to '1'.
01 
BACnet joining processing is started. 1 
After the module has joined to BACnet, the value of X2 is changed
to '1'.
01 
A BACnet communication is started. 1 
Operation of a BACnet
module
X0 X1 X2 Operation in a program Y1 Remarks
The BACnet communication is
stopped.
100 0 
The [Restart] button is clicked in a
configuration function.
When the [Restart] button is
clicked in a configuration function,
the value of X1 is changed to '1'.
01 
 1 When the value of X1 is changed
to '1', the initial value is written to
the buffer memory.

 After the initial value is written, the
value of Y1 is changed to '1'.
01 
When the value of Y1 is changed
to '1', BACnet joining processing is
started.
 1 
After the module has joined to
BACnet, the value of X2 is
changed to '1'.
01 
A BACnet communication is
started.
1 