172
APPX
Appendix 3 Buffer Memory Areas
CH1 Time average/Count average/Moving average/Primary delay filter constant setting
Configure the time (for averaging), count (for averaging), moving average count, and primary delay filter constant when
values other than Sampling processing (0) is set for 'CH1 Averaging process specification' (Un\G501).
The following table lists the setting ranges.
If a value other than the above is set, any of a time average setting range error (error code: 192H), count average setting
range error (error code: 193H), moving average setting range error (error code: 194H), or primary delay filter constant
setting range error (error code: 195H) occurs, and the A/D conversion process is performed with the setting before the
occurrence of the error.
■Buffer memory address
The following shows the buffer memory address of this area.
•CH Time average/Count average/Moving average/Primary delay filter constant setting
•CH Time average/Count average/Moving average/Primary delay filter constant setting (in Q compatible mode)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 0 for all channels.
• Set a primary delay filter constant for the primary delay filter. The value of the time constant (ms) is the
product of the primary delay filter constant and the sampling cycle.
• Since the default value is 0, change the setting value according to the processing method.
• The setting for this area is ignored in the channel where Sampling processing (0) is set to 'CH1 Averaging
process specification' (Un\G501).
Setting value Setting content
40 to 5000 (ms) Time average
4 to 500 (times) Count average
2 to 200 (times) Moving average
1 to 500 (times) Primary delay filter constant
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
502 702 902 1102 1302 1502 1702 1902 2102 2302 2502 2702 2902 3102 3302 3502
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
12345678
To Next Page
Loading...
