Mitsubishi Electric R60AD8-G - Page 175

APPX
Appendix 3 Buffer Memory Areas
173
A
CH1 Scaling enable/disable setting
Set whether to enable or disable the scaling.
For details on the scaling function, refer to the following.
Page 26 Scaling Function
If a value other than the above is set, a scaling enable/disable setting range error (error code: 1A0H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
•CH Scaling enable/disable setting
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (1) for all channels.
Scaling enable/disable setting [Q compatible mode]
When the Q compatible mode function is used, set whether to enable or disable the scaling.
■Buffer memory address
The following shows the buffer memory address of this area.
Only the R60AD8-G can use this area.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (1).
Setting value Setting content
0 Enable
1 Disable
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
504 704 904 1104 1304 1504 1704 1904 2104 2304 2504 2704 2904 3104 3304 3504
(1) 0: Enable, 1: Disable
(2) b8 to b15 are fixed to 0.
Buffer memory name CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Scaling enable/disable setting (in Q compatible
mode)
53
CH1CH2CH3CH4CH5CH6CH7CH8CH1CH2CH3CH4CH5CH6CH7CH8
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b0b1b2b3b4
(1)(2)