Mitsubishi Electric R60AD8-G - Page 176

174
APPX
Appendix 3 Buffer Memory Areas
CH1 Scaling upper limit value
Set an upper limit value for the range of the scale conversion.
For details on the scaling function, refer to the following.
Page 26 Scaling Function
■Buffer memory address
The following shows the buffer memory address of this area.
•CH Scaling upper limit value
•CH Scaling upper limit value (in Q compatible mode)
■Setting range
The setting range is from -32000 to 32000.
In the channel where a value out of the range is set, a scaling setting range error (error code: 1A1H) occurs.
In the channel where a set value does not satisfy the condition "the scaling upper limit value  the scaling lower limit value", a
scaling upper/lower limit value setting error (error code: 1A2H) occurs.
When 'CH1 Scaling enable/disable setting' (Un\G504) is set to Disable (1), the setting for 'CH1 Scaling upper limit value'
(Un\G506) is ignored.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 0 for all channels.
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
506 706 906 1106 1306 1506 1706 1906 2106 2306 2506 2706 2906 3106 3306 3506
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
63 65 67 69 71 73 75 77 