Mitsubishi Electric R60AD8-G - Page 194

192
APPX
Appendix 3 Buffer Memory Areas
CH1 Trigger data
Set a buffer memory address to be monitored using a level trigger.
Set the buffer memory address where the target data for monitoring is stored.
For details on the logging function, refer to the following.
Page 61 Logging Function
■Buffer memory address
The following shows the buffer memory address of this area.
•CH Trigger data
■Setting range
The setting range is from 0 to 9999.
If a value out of the range is set, a trigger data setting range error (error code: 1D6H) occurs. Logging cannot be performed.
When 'CH1 Logging enable/disable setting' (Un\G535) is set to Disable (1), the setting for 'CH1 Trigger data' (Un\G541) is
ignored.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default values are set as shown below.
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
541 741 941 1141 1341 1541 1741 1941 2141 2341 2541 2741 2941 3141 3341 3541
Channel Default value Buffer memory area to be monitored
CH1 402 'CH1 Digital operation value' (Un\G402)
CH2 602 'CH2 Digital operation value' (Un\G602)
CH3 802 'CH3 Digital operation value' (Un\G802)
CH4 1002 'CH4 Digital operation value' (Un\G1002)
CH5 1202 'CH5 Digital operation value' (Un\G1202)
CH6 1402 'CH6 Digital operation value' (Un\G1402)
CH7 1602 'CH7 Digital operation value' (Un\G1602)
CH8 1802 'CH8 Digital operation value' (Un\G1802)
CH9 2002 'CH9 Digital operation value' (Un\G2002)
CH10 2202 'CH10 Digital operation value' (Un\G2202)
CH11 2402 'CH11 Digital operation value' (Un\G2402)
CH12 2602 'CH12 Digital operation value' (Un\G2602)
CH13 2802 'CH13 Digital operation value' (Un\G2802)
CH14 3002 'CH14 Digital operation value' (Un\G3002)
CH15 3202 'CH15 Digital operation value' (Un\G3202)
CH16 3402 'CH16 Digital operation value' (Un\G3402)