Mitsubishi Lancer Evolution-IV - HEADLAMP; SERVICE SPECIFICATIONS

CHASSIS ELECTRICAL – Headlamp
54-32
HEADLAMP
SERVICE SPECIFICATIONS
Items Standard value Limit
Headlamp
aiming
High
beam
Vertical direction 25’ (22 mm) below horizontal line –
a
i
m
i
ng
[Parenthe-
sized are
allowable
b
eam
Horizontal
direction
Left head-
lamp
Parallel to direction of vehicle travel –
a
ll
owa
bl
e
beam axis
deviations 3
m ahead of
Right head-
lamp
15’ (13 mm) leftward from vertical line (V) –
m ahead of
headlamp.]
Low
beam
Vertical direction 25’ (22 mm) below horizontal line –
p]
b
eam
Horizontal direction Position where 15* rising section intersects
vertical line (V)
–
Headlamp intensity cd (Center of high-beam high intensity
zone)
– 15,000 or
more per
light
Cautions in Handling Headlamp Assembly
Each headlamp assembly has a plastic outer lens on. Observe the do’s and don’ts below when
handling the headlamps.
D Do not leave the headlamps lit for longer than 3 minutes with a protective cover on.
D Do not mask the outer lens surface by taping or in any other way.
D Do not scrub the outer lens surface with a pointed tool.
D Use the designated wax remover for cleaning the outer lens surface. Rinse it thoroughly.
D Use the designated genuine bulbs.
SPECIAL TOOLS
Tool Number Name Use
MB991502 MUT-II sub as-
sembly
ETACS-ECU input signal checking