FULL-AUTOMATIC AIR CONDITIONER – Troubleshooting
55-53
Inspection procedure 16
A/C compressor control circuit check
Measure at the A/C-ECU connector B-05.
D Blower switch and A/C switch: ON
D Setting temperature: 17_ C
D Connect the connector.
D Voltage between terminal (34) and body earth (Ignition
switch: ON)
OK: System voltage
NG
Check the following connector:
B-05
NG
Repair
OK
Check the trouble symptom.
NG
Replace the A/C-ECU.
OK
Measure at the A/C compressor relay connector A-116X.
D Disconnect the connector, and measure at the harness
side connector.
D Voltage between terminal (2) and body earth
OK: System voltage
NG
Check the following connectors:
A-49, B-15, B-05
NG
Repair
OK
Check the trouble symptom.
NG
Check the harness between the A/C-ECU and the A/C compressor
relay, and repair if necessary.
OK
Measure at the engine-ECU connector B-54 or B-59.
D Disconnect the connector, and measure at the harness
side connector.
D Voltage between terminal (21) or (22) and body earth
OK: System voltage
NG
Check the following connectors:
A-28, A-116X
NG
Repair
OK
Check the trouble symptom.
NG
Check the harness between the A/C compressor relay and the
engine-ECU, and repair if necessary.
OK
Replace the engine-ECU.
To Next Page
