ENGINE – Crankshaft and Flywheel
11-70
(4) Tighten the bolts to 25 Nm in the specified tightening
sequence.
(5) Make a paint mark on the head of each bolt.
(6) Make a paint mark on the bearing cap at the position
90° from the paint mark made on the bolt in the direction
of tightening the bolt.
(7) According to the specified tightening sequence, give a
90° turn to each bolt and make sure that the paint mark
on the bolt and that on the cap are in alignment.
Caution
If the bolt is turned less than 90°, proper fastening
performance may not be expected. When tightening
the bolt, therefore, be careful to give a sufficient turn
to it.
(8) After installing the bearing caps, make sure that the
crankshaft turns smoothly and the end play is correct.
If the end play exceeds the limit, replace No. 3 crankshaft
bearings.
Standard value: 0.05 – 0.25 mm
Limit: 0.4 mm
"DA OIL SEAL INSTALLATION
Using the special tool, knock the oil seal into the oil seal
case.
Arrow mark
6AE0299
Paint mark
Paint mark
90°
To Next Page
Loading...
