9 - 4 9 - 4
MELSEC-Q
9 TROUBLESHOOTING
(3) Confirmation of Module’s detailed information
Check the module information, the LED statuses, and the statuses of setting with
the intelligent function module from "H/W Information" of Module's detailed
information that can be displayed on the system monitor of GX Developer
(Version 7.17T or later).
[Setting procedure]
Chose [Diagnostics]
[System monitor]
"QD60P8-G module" and
choose "Module’s Detailed Information"
H/W Information
.
[H/W LED Information]
H/W LED information displays the following information.
Item Signal name Value
RUN "RUN" LED of QD60P8-G
ERR "ERR." LED of QD60P8-G
0: LED OFF
1: LED ON
[H/W SW Information]
The setting status of the intelligent function module switches are displayed.
Item Signal name Corresponding switch Value
INPUT V Input voltage selection Switch 1
PLS EDGE Pulse edge selection Lower 8 bits
RNG LIN Linear counter or Ring counter selection
Switch 2
Upper 8 bits
FIL 4-1 Input filter setting (CH1 to CH4) Switch 3
FIL 8-5 Input filter setting (CH5 to CH8) Switch 4
NOP
Switch 5
For details, refer to "Section 4.5
Switch setting for intelligent
function module".
To Next Page
Loading...