Mitsubishi QD60P8-G - 8.3 Online Module Change Procedure

8 - 4 8 - 4
MELSEC-Q
8 ONLINE MODULE CHANGE
8.3 Online Module Change Procedure
The online module change procedure is explained separately for the case where GX
Configurator-CT was used for initial setting and for the case where a sequence
program was used for initial setting.
8.3.1 GX Configurator-CT was used for initial setting
(1) Operation stop
Turn OFF all output signals (Y devices) from the sequence program or the device
test of GX Developer to stop the module operation.