Mitsubishi QD60P8-G User Manual

4 - 2 4 - 2
MELSEC-Q
4 SETUP AND PROCEDURE BEFORE OPERATION
4.2 Procedure before Operation
The figure below shows the steps that should be followed before starting the QD60P8-
G operation.
Perform the monitor or test using the
GX Configurator-CT (Refer to Section 6.6).
Monitor/Test
Create and check the sequence program
(Refer to Chapter 7).
Program and debugging
Create a sequence program for writing
initial values (Refer to Chapter 7).
Initial setting
Perform settings using the GX Developer
(Refer to Section 4.5).
Intelligent function module switch setting
Module mounting
Mount the QD60P8-G in the specified slot.
Yes
No
N
o
Yes
Wiring
Wire the QD60P8-G.
Start
Use the GX Configurator-CT?
Operation
Initial setting
Perform the initial setting using the
GX Configurator-CT (Refer to Section 6.4).
Perform auto refresh setting?
Auto refresh setting
Perform the auto refresh setting using the
GX Configurator-CT (Refer to Section 6.5).
4

Mitsubishi QD60P8-G Specifications

General

Brand	Mitsubishi
Model	QD60P8-G
Category	Controller
Language	English