Mitsubishi RC-EX3

－ 71 －
This does not indicate a failure; the message indicates that the unit is
controlled through a central control device.
[Operations allowed during central control]
・
Filter sign reset
・
Administrator settings
■
“ Invalid request. Central control active.” display
When the unit is controlled through a central control device (not included), and you performed an operation other than
the followings, the message “Invalid request. Central control active.” is displayed.
Menu
Direction
Cooling
16：32 (Mon)
F1: High power F2: Energy-saving
Timer
Invalid request. Central control active.
Set temp
CENTER
These messages will be displayed when the unit is operated through IO
external input.
This does not indicate a failure; the message indicates that the unit is
operated through IO external input.
■
“In temporary stop mode”, “In forced thermostat OFF”, “In setting
temperature shift” displays
Menu
Direction
Cooling
16：32 (Mon)
F1: High power F2: Energy-saving
Timer
In temporary stop mode
Set temp
When rotation, capacity back-up, or fault back-up operation is enabled
during installation, a message indicating the operation that is set and
running will be displayed on the message display.
Refer to the installation manual on how to make these settings.
■
“ In operation for rotation.”, “In operation for capacity back-up”,
“ In operation for fault back-up” displays
Menu
Direction
Cooling
16：32 (Mon)
F1: High power F2: Energy-saving
Timer
In operation for rotation.
Set temp