13
1 Before Using This Product
No. 99MAF029B
5
Display [5] in ones place using the same procedure described in steps
3
and
4
.
6
Slowly bring the probe into contact with the 25 mm gauge block until a beep sound is made.
»
The origin setup is complete.
Tips
For measurements using a dial test indicator or dial indicator, bring the stylus into contact with the
gauge block, and then press to finish the setup.
Setting the INC origin
1
Press .
2
Slowly bring the probe into contact with the desired origin point until a beep sound is made.
»
The origin setup is complete.
To Next Page
Loading...
Need help?
General
