Mitutoyo QM-Height Series - Preparing Measurements; Setting the INC Reference

11
1 Before Using This Product
No. 99MAF600B
y Incremental measurement (INC) reference
This method uses an arbitrary point on the workpiece as the reference. The specied point acts as
the reference for the measurements and is assigned a value of 0 mm.
Example: Surface a1 is set as the reference (normally 0 mm).
a1
Obtain the measurement relative to a1
Tips
For details about setting the INC reference, "■ INC reference setup" (page 13)

ABS reference setup
z
Setting the surface plate as the reference
1
Press .
2
Conrm that [+000.000] is displayed on the LCD screen.
If a different value is displayed, use , , , or to change the value to [+000.000].
Tips
For details about conguring the settings, "● Setting a point other than the surface plate as the reference"
(page 12)
3
Slowly bring the ball of the probe into contact with the surface plate until a beep sound is made.
» Reference setup is complete.