© MOBATIME 19 / 52 800693.16
4 Control of the clock using IR remote control
A 2-digit address is assigned to the clock. With the IR remote control the clock can be locked.
The setting of time, date and the clock parameters can only take place at clocks in an
unlocked state.
Function of the pushbuttons in normal display mode
pushing F1 + entry of 2-digit address, unlock the clock with the
using numerical pushbuttons corresponding address
holding down F1 button unlock all clocks within the reach of the IR
beam of the remote control unit
holding down F2 button lock all clocks within the reach of the IR
beam of the remote control unit
holding down F3 button display the address of all locked clocks within
the reach of the IR beam of the remote control
Function of the pushbuttons in the “Clock“ operation mode
SET entry into the time and date setting mode
The + button button brightness increase (not applicable when
P0 is set to A)
The - button button brightness decrease (not applicable when
P0 is set to A)
CLOCK visualization of time
DATE visualization of date
TEMP visualization of temperature
TIMER visualization of stopwatch
MENU entry into the menu of setting of clock
parameters
CLR time correction to the whole minute (±30 sec)
4.1 Setting of time and date
The time and date values are adjusted in the following sequence: year – day – month –
hours – minutes. By pushing the SET button, enter the time and date setting mode.
The display shows the following:
The item to be set is blinking.
After having set up the minutes the value is blinking. By pushing the OK button the
value is stored (with seconds reset to zero) and the clock operation resumes. The clock
returns into normal working mode.
Note: When the time zone of displayed time and date (menu item P7) is set to the
values U1 – U7 or U, the entered time and date is taken as UTC.
To Next Page
Loading...
