Mobatime DC.57.4 - DHCP Network Parameter Assignment; Manual Network Setup; Telnet Network Configuration

© MOBATIME 38 / 52 800693.16
multicast config address
239.192.54.1 / FF38::EFC0:3601
(FF38::239.192.54.1)
alive notification interval
[min]
30
configuration port number
65532
time zone client port
number
65534
DHCPv4
enabled
SNMP
enabled
Multicast support
enabled
Telnet
enabled
IPv6 fix address / prefix
0:0:0:0:0:0:0:0/ 64
IPv6 link local address
fe80::2[2. octet MAC]:[3. octet MAC]ff:fe[4. octet
MAC]:[5. octet MAC][6. octet MAC]
DHCPv6
enabled
autoconfiguration (SLAAC)
enabled
11.1.1 Network parameters assignation by DHCP
IP clock mode must be set to IPv4 mode (P18: 0/1).The menu item P19 must be
set to value 3 (default). Network parameters are automatically obtained from a
DHCPv4 server.
The following DHCP options will be evaluated automatically:
[50] IP address
[3] Gateway address
[1] Subnet mask
[42] list of up to four NTP server addresses / time zone server address (usually
the same as the NTP server address)
[6] DNS servers
[26] MTU
[60] Vendor Class ID
[43] or [224] Additional options (refer to document BE-800793)
The network administrator must configure the DHCPv4 options accordingly.
Assigned parameters can be checked in the submenu of items P20 to P22.
11.1.2 Manual setting through setup menu
The menu item P19 must be set to value 2.
• See chapter 4.2.4 for setting the clock’s IP address in the item P20
submenu
• See chapter 4.2.5 for setting the subnet mask in the item P21 submenu
• See chapter 4.2.6 for setting the gateway in the item P22 submenu
• See chapter 4.2.7 for setting the multicast group address in the item P23
submenu
• See chapter 4.2.8 for setting the unicast NTP server address in the item
P24 submenu.
11.1.3 Manual setting through telnet
• connect to the clock and make the needed settings by windows command
telnet <IP address>
example: telnet 192.168.0.190
• request for entering the password appears after connection (default
password is 718084)