© MOBATIME 28 / 52 800693.16
7 Control of the stopwatch using IR remote control
A 2-digit address is assigned to the stopwatch. With the IR remote control, the stopwatch can
be locked. Controlling and the stopwatch parameter adjustment are only allowed in unlocked
state.
Function of the pushbuttons in the “Stopwatch“ mode
pushing the F1 button + entry unlocking of a clock with the corresponding
of 2-digit address using numerical address
pushbuttons
holding down the F1 button unlocking of all clocks within the reach of the IR
beam of the remote control
holding down the F2 button locking of all clocks within the reach of the IR
beam of the remote control
holding down the F3 button display of the addresses of all locked clocks
within the reach of the IR beam of the remote
control
CLOCK visualization of time
DATE visualization of date
TEMP visualization of temperature
TIMER visualization of the stopwatch
MENU entry into stopwatch parameter setup menu
SET entry into setting initial time of counting down
S/S, HOLD, RES function depends on the stopwatch operation
mode set
7.1 The stopwatch menu
The stopwatch menu is entered by pushing MENU button (stopwatch must be
displayed). The parameter adjustment is shown in the stopwatch menu table (chapter
8).
Function of the pushbuttons in the “Stopwatch Menu“ operation mode
>> storing the current value and transition
to another menu item
<< storing the current value and transition to
previous menu item
The + button increase of the adjusted value in steps of 1
The - button decrease of the adjusted value in steps of 1
Holding down the + button continuous increase of the item set up
Holding down the - button continuous decrease of the item set up
ESC return into normal display mode,
OK storage of the parameters; return into the stopwatch
display mode when counting up from zero; or entry into
the initial time setting mode when counting down
To Next Page
Loading...
