Monarch 9906 - Job Status 0, 1, 2 Response Table (Status 1 Codes)

7-8 Packet Reference Manual
The following syntax is the response for a Job 4 request.
Syntax {J,printed,total,"FMT-1","BCH-2"}
Printed the number of tags or labels remaining in the batch to print.
Total the total number of tags or labels to be printed in the current batch.
“FMT-1/BCH-2" The format or batch number is returned.
Example {J,8,25,"FMT-3","Bch-2"}
8 out of 25 tags or labels are left to print from format number 3.
Use a Job Request 4 when printing in the on-demand mode with a large number of tags or labels
from a single batch. A Job Request 4 may not be accurate if tags or labels are printed in
continuous mode, because of the response time involved. A Job Request 4 is not useful in single
ticket batches (printing 1 of 1) or multiple single ticket batches.
Note: A batch has to be printing when you send the job request. You cannot use this job
request on batches printing formats with incrementing fields.
Job Status 0, 1, 2 Response Table (Status 1 Codes)
Number
Meaning
0
No error
1
Stacker Fault
2
Supply problem
4
Hot printhead
5
Printhead open
6
Insufficient memory
7
Ribbon problem
8
Field ## extends off tag
9
Field ## has a bad font/bar code
10
Field ## contains invalid data
11
Field ## has a graphic missing
12
Invalid communication channel
13
Invalid file type
14
All communication channels are busy
15
Receive overrun error
16
Receive parity error
17
Receive framing error
18
Receive buffer full
19
Label waiting
21
Bad dots (verifier detected a failure)
23
Low battery
24
Memory configuration packet error
Numbers 25 through 50 are not currently in use.