B-6 Packet Reference Manual
96 97 98 99 100 101 102 103
Dry clean, No
Trichloro-
ethylene
Dry clean,
Petroleum
Solvent Only
Dry clean,
Any Solvent,
Short Cycle
Dry clean, No
Trichloro-
ethylene,
Short Cycle
Dry clean,
Petroleum
Solvent Only,
Short Cycle
Dry clean,
Any Solvent,
Reduced
Moisture
Dry clean, No
Trichloro-
ethylene,
Reduced
Moisture
Dry clean,
Petroleum
Solvent Only,
Reduced
Moisture
104 105 106 107 108 109
Dry clean,
Any Solvent,
Low Heat
Dry clean, No
Trichloro
ethylene,
Low Heat
Dry clean,
Petroleum
Solvent Only,
Low Heat
Dry clean,
Any Solvent,
No Steam
Dry clean, No
Trichloro
ethylene, No
Steam
Dry clean,
Petroleum
Solvent Only,
No Steam
Use the tilde sequences shown in this table to produce the desired character on your tags/labels.
{F,1,A,R,E,200,200,"Font72" |
T,1,10,V,25,25,0,72,2,2,B,L,0,0|
T,2,10,V,65,65,0,72,1,1,B,L,0,0|}
{B,1,N,1|
1,"~042 ~067"|
2,"~080 ~087"|}
Bitmap Font Information
Our bitmap fonts are either monospaced (each character occupies the same amount of space) or
proportional (each character is a different width). Use monospaced fonts for price fields and data
you want to list in a column. With proportionally spaced fonts, you may be able to place more
characters on a line. However, you may need to experiment with these fonts and adjust field
measurements in your format. The bitmapped fonts (either monospaced or proportional) appear
jagged when magnified. The magnification range is 1 to 7.
Use the MONARCH® MPCL™ Toolbox (Font Utility), available on our Web site, to convert a
bitmap font to Hex or Run-Length encoding for the printer. Select the point size and characters
to print. Bitmap fonts may image faster than a TrueType font, but you are limited to the point
size and characters you downloaded.
Monospaced Font Magnification
Monospaced characters occupy the same amount of space within a magnification. Use
monospaced fonts for price fields and data you want to list in a column. Decide how wide and tall
you want the characters to appear on the labels.
Only the 1x width can be scanned with the OCRA-like font. Using a printhead with 203 dpi, the
character widths are as follows: 7.9 (English), 20.1 (Metric), and 16 (Dots).
To calculate other font widths, multiply the font dots (14 dots for Standard, 7 dots for Reduced,
24 dots for Bold) by the magnification and add the default spacing (3 dots for Standard, 1 dot for
Reduced, 3 dots for Bold) between characters.
Example
14 (Standard font dots) x 5 (magnification) = 70 + 3 (default spacing between characters). There
are 73 dots in the Standard font at 5x.
To Next Page
Loading...
