2-14 Packet Reference Manual
Command Parameter
Checks the RFID hardware version.
^RS
Resynchronizes supply when supply roll is changed.
Note: Printer ignores this command if printing.
^SD or
^SCd
Disables the status polling feature by turning off the status polling control
character. Sets the status polling control character to the ASCII value given by
the d parameter. The value of d can be any ASCII character.
^SFa
Loads script with host response.
^SFb
Loads script without host response.
Enables script.
^SFd
Disables script.
^SFe
Uploads script version information.
Deletes script.
Turns on ENQ status polling before it reaches the script.
Turns off ENQ status polling before it reaches the script.
Turns on immediate commands before it reaches the script.
^SFj
Turns off immediate commands before it reaches the script.
^TP
Prints a test label.
Note: Printer ignores this command if printing.
^VLC
Only clears the data that has been uploaded, not all the logged data. Data is
cleared with this command after a successful upload. We recommend clearing
the log file after uploading.
^VLU
Uploads the log file to the last port that received host data (serial, parallel,
USB, or Ethernet). Repeat this command until data is successfully uploaded.
Data can be cleared after it has been uploaded.
Note: To use the immediate command control character or the status polling character within
your data, use the tilde sequence.
To Next Page
Loading...
