Defining Fields 3-3
T7. gap Number of dots between characters 203 dpi or 300 dpi. Range: 0 to
99. 0 is the default.
Note: For monospaced fonts, the additional spacing is added to the existing
inter-character gap. This is also true for proportionally spaced fonts, but
the inter-character gap varies with character combinations.
Any number other than 0 or the default number affects your field width.
Default spacing:
Standard 3 dots
Reduced 1 dot
Bold 3 dots
OCRA-like 3 dots
CG Triumvirate™ Typeface Bold varies with each letter
CG Triumvirate™ Typeface varies with each letter
T8. font Style of font. 1 is the default. Options:
1 Standard 10 CG Triumvirate™ Typeface Bold
2 Reduced 11 CG Triumvirate™ Typeface
3 Bold 15 7 pt. CG Triumvirate™ Typeface
4 OCRA-like 16 9 pt. CG Triumvirate™ Typeface
5 HR1 17 11 pt. CG Triumvirate™ Typeface
6 HR2 18 15 pt. CG Triumvirate™ Typeface
50 EFF Swiss Bold (TrueType® Scalable)
56 PaxarSymbols
Or a valid downloaded font selector number.
Fonts 5 and 6 are for numeric data only. The CG Triumvirate™
typefaces support only the ANSI and DOS Code Page 437 and 850
Symbol Sets. The scalable font does not support Code Page 1256
(Arabic). See Appendix C for more information.
T9. hgt mag Height magnifier, 1 to 7 times (4 to 255 points for scalable/downloaded
TrueType fonts). 1 is the default. Use a magnifier of 1 with
proportionally spaced fonts, because characters lose smoothness at
higher magnifications. See Appendix B, “Fonts,” for more information
about fonts.
T10. wid mag Width magnifier, 1 to 7 times (4 to 255 points for scalable/downloaded
TrueType fonts). 1 is the default. Proportionally spaced fonts do not
have a set width. To estimate the size of your field, use the letter “W”
for the widest field or an “L” for an average width field. Find your
selected font and the desired width in Appendix B, “Fonts.”
To Next Page
Loading...
