Moog Infinity User Manual

Innity
®
Enteral Feeding Pump Operator’s Manual
16
2. DIRECTIONS FOR USE
Feeding Completion:
When the dose has been completely delivered,
pump will stop running and display will read NEXT
DOSE then give the number of hours and minutes
until feeding will be repeated (Figure 2-26). Display
will show the run symbol ashing without the arcs
rotating around it. Pump will repeat this cycle until
disposable set is empty or until it is stopped by user.
NOTE: When a feed interval has been programmed,
pump will not alarm DOSE DONE. Pump will
cycle continuously as long as feeding solution
remains in the bag. When empty, pump
will alarm NO FOOD or NO FLOW IN.
To stop feeding, press the ON/OFF key for 1.5
seconds to turn pump o or press the RUN/PAUSE
key to put pump in pause mode. Adjustments
to settings can be made at this time.
New Feeding Cycle:
Turn pump on. Previous settings for rate, dose, and feed interval
will be saved in memory. If no changes are required, verify
each setting is correct and restart pump running.
NOTE: Rate, dose, and feed interval settings can be locked into place
so that changes cannot be made. See the User Preference Settings
section (Page 19) for instructions to change this feature.
Figure 2-26 Time Until
Next Feeding

Moog Infinity Specifications

General

Model	Infinity
Type	Infusion Pump
Occlusion Pressure Settings	Low, Medium, High
Alarms	Occlusion, Low battery
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to 60°C
Manufacturer	Moog
Infusion Modes	Continuous, Intermittent
Display	LCD
Compatibility	Standard infusion sets