© Copyright 2020 Moog, Inc.
15
2. DIRECTIONS FOR USE
Step 8:
Press the RUN/PAUSE key. Pump will begin
running. Display will show programmed rate,
the arcs around the run symbol will rotate and
display will read FEED INTERVAL (Figure 2-23).
While pump is running the following
may be viewed by pressing
the appropriate key: Rate, Dose, and Feed Interval.
To view the amount delivered in the current
feeding, press the VOL/TOTAL key (Figure 2-24).
This counter will reset itself when the previously
programmed dose has been completed and a new
feeding is started, or if a feeding is interrupted
and Rate, Dose or Feed Interval is changed.
To view the amount delivered over the course
of several feedings press the VOL/TOTAL key
a second time (Figure 2-25). Display will read
TOTL then the amount. This counter never
resets itself, it can only be reset by the user.
While pump is running, the settings cannot be
changed and the Prime feature is disabled.
If you want to stop pump at any time, press the RUN/PAUSE key. Display will show rate,
and pump will be in pause mode. Or, turn pump o by pressing the ON/OFF key.
When you would like to restart pump, press the ON/OFF and/or the RUN/PAUSE
key. Pump will save the memory of where it was in the feeding before stopping.
Press the RUN/PAUSE key and pump will restart at the point where it was stopped.
NOTE: Any changes to pump settings during a feeding cycle will cause
pump to start a new feeding; it will not start where it left o.
Figure 2-23 Pump is Running
Figure 2-24 Amount
Currently Delivered
Figure 2-25 Total
Amount Delivered
To Next Page
Loading...
