Inserting Cables through the 3-Hole Grommet
Note: The Ethernet cable must be uncrimped to perform this procedure.
The camera includes an I/O terminal for input/output and audio connections, an external power connector,
and an Ethernet connector. If you are connecting 2 or more cables to the camera, follow this procedure for
using the 3-hole sealing grommet to insulate the cables from the weather.
1. Remove the sealing grommet from the accessory kit.
2. Thread the Ethernet cable into the largest hole in the 3-hole rubber grommet.
a. Push the Ethernet cable through the open hole in the rubber grommet.
Ensure the orientation of the cable and grommet matches the following image.
b. Crimp the connector onto the Ethernet cable.
Inserting Cables through the 3-Hole Grommet 15
To Next Page
Loading...
